British Columbia, Canada
Takakkaw Falls is a moderately high volume waterfall along the unnamed stream flowing from the Daly Glacier in British Columbia's Yoho National Park. The falls drop a total of 992 feet in four distinct steps, first dropping over two narrow plunges hidden within the slot canyon at the top of the falls (neither of which can be seen from the base of the falls). The river then hurtles 853 feet over the side of the Yoho Valley wall, then cascading down a narrow flume-like stairstep for an additional 94 feet. The falls are frequently cited as dropping 1,248 feet (380 meters), but this seems to be a generalized overestimate (based on what, we are not certain). Some sources list a height of 1,650 feet as well, but this refers to the total change in elevation between the lake below the Daly Glacier and the Yoho River. It should be noted that our measurements of this waterfall were derived using both a laser and a GPS, and have a slightly wider margin of error than with a laser alone - perhaps as much as +/- 40-50 feet.
<br />The falls are fed by the meltwater of the Daly and Niles Glaciers, as well as an unnamed lake below the Daly Glacier and several small glacial remnants. While the stream from the Daly Glacier is one of the largest produced by the Wapta Icefield, it doesn't appear to have ever been uniquely labeled. Though the stream does flow all year long, because of the cold temperatures in the winter, the volume is greatly reduced until the snow begins to melt. The falls are usually flowing the heaviest from July to September, specifically during the mid to late afternoon hours.
<br />Takakkaw Falls possesses several unique features which set it apart in the world of waterfalls. First and foremost is the massive roostertail which is exhibited during heavier flow periods. As the river drops out of the slot canyon at the top of the main drop, it falls for about 75 to 100 feet before impacting on a protruding rock which forces the water to shoot outwards from the cliff face by as much as 150 feet. Additionally, at the top of the falls, the river drops into several sinks and karstic tunnels prior to falling over the main fall. These features cannot be seen, however, without climbing to the top of the 1000 foot cliff adjacent to the waterfall.
History and Naming
Takakkaw Falls is the Official name of this waterfall.
Takakkaw is said to be a Cree word meaning Magnificent - which couldn't be any less appropriate for this particular waterfall. The exact date of naming isn't known, but as nearby Emerald Lake was discovered in 1882, the discovery and naming of this waterfall probably predates the onset of the 20th century.
While its not a terribly unique waterfall, the powerful jet of water that shoots out from the cliff sets this one aside from many of the other large waterfalls around North America. Takakkaw Falls simply exudes power and though it isn't nearly the tallest waterfall in Canada, it is without question one of the world's elite cataracts.
Takakkaw Falls can be seen literally for miles around and there are numerous different compositions available.
Location & Directions
Coordinates: 51.5001262, -116.472991 Elevation: 0 feet
Takakkaw Falls is located at the end of the Yoho Valley Road in Yoho National Park. The road and falls are heavily signed from Highway 1, and once on the right road, the falls can’t be missed. A caution to motorists – those planning on visiting the falls with a trailer or RV should plan on having an alternative method of transportation, because a pair of extremely sharp switchbacks in the road up the valley limits navigable vehicle lengths to about 25 feet.View this location in Google Earth Takakkaw Falls is marked with the large icon in the center of the map. Up to ten additional waterfalls (if any) may be marked as well, with links below.
Other Nearby Waterfalls
By The Numbers
The information presented in this table is meant to help identify and clarify the physical aspects of the waterfall for comparative purposes. While we try to ensure this information is as accurate as possible, sometimes it will prove necessary to either estimate or flat out guess at certain characteristics where either enough information isn't readily available, is not known, or we were not able to confirm a given trait upon surveying. This information may be changed at any given time to ensure accuracy.
The Total Height listed for the waterfall represents the difference in elevation from the top of the uppermost drop, to the bottom of the lowermost drop of the waterfall, including all stretches of interstitial stream in between. Stream between two tiers of a waterfall is counted in its overall height regardless of whether or not that section of the stream would be legitimately considered a waterfall on its own right, were it to be isolated. Waterfalls with only one drop will of have the height of only the single drop listed here.
The Tallest Drop figure represents the height of the largest single drop within a multi-stepped waterfall. Waterfalls with only one drop will have the total height of the waterfall repeated here.
Num of Drops
The Number of Drops in a waterfall is a tally of the total number of distinct drops which make up the waterfall. Stretches of interstitial stream in between two or more distinct drops of a single waterfall are NOT considered to be distinct drops of the waterfall unless the section of stream in question would otherwise qualify as a waterfall were it to be isolated.
The Average Width of the waterfall represents the breadth of the waterfall from bank to bank under typical flow conditions, or if the waterfall has been Cataloged, under the conditions which it was most thoroughly surveyed. Often this number will be approximated because of a lack of approachability to many waterfalls. We often utilize Google Earth to measure the width (where imagery is of sufficient quality and resolution to allow it.
Maximum Width represents a hypothetical measurement of roughly how wide a waterfall could get during peak streamflow or flood conditions. For smaller waterfalls, this figure will generally not differ much from the Average Width measurement, but for broader waterfalls - especially those that feature a crest that isn't constricted - this figure can at times be consideraby larger. Like the Average Width measurement, this measurement will take into account the difference in width at the top and bottom of the waterfall as much as possible, but will often be made based on the width of the crest of th falls alone.
The Pitch of a waterfall is an estimated - often very roughly - measure of the average slope or steepness of a waterfall. The Pitch figure only takes into account sections of stream which are actively falling. Pools or stretches of level stream in between two or more successive drops of the falls will not factor in this figure. As an example, a waterfall which features two truly free-falling leaps separated by several dozen yards of flat stream will have a Pitch of 90 degrees. Similarly, a waterfall with two drops separated by a pool, one with a true free-falling drop, and one with a Horsetail type fall will average the two, so while the Plunging drop has a Pitch of 90 degrees, if the Horsetail drop has a Pitch of 45 degrees, the total Pitch will be roughly 67 degrees.
The Run of a waterfall is a measurement representing the total linear distance on the ground between the top and bottom of a waterfall. This figure is not often easy to establish with a high degree of precision and as such will often be estimated. Waterfalls with a longer Run will usually either be less steep, often cascading type waterfalls, or will feature multiple steps separated by shorter stretches of a more gradual gradient streambed.
The system of classification of waterfall forms we use is a heavily modified derivative of the classifications outlined by Greg Plumb in his "Waterfall Lover's Guide to the Pacific Northwest" books. While plumb uses eight distnct forms, we wanted further granularity and opted to break down the hierarchy twofold: first based on the overall pitch of the waterfall, and then based on what shape the fall takes as it makes its descent. There are five primary Categories of falls in this system: Plunge, Horsetail, Steep Cascades, Shallow Cascades, and Rapids. Additional deliniation is then applied depending on characteristics such as the breadth of the falls, whether it splits into two or more channels, whether it falls in multiple successive drops, etc. For more information on our waterfall form classifications, see the Help page.
The watershed which a waterfall occurs within, if it is specified, will be based on the ultimate distributary watercourse to the ocean. For example, Washington's Palouse Falls occurs along the Palouse River - which is a tributary to the Snake River, which is itself a tributary to the Columbia River, which ultimately enters the Pacific Ocean, so Palouse Falls would then fall within the Columbia River watershed. Streams which empty directly into the ocean, or into a minor basin which then empties to the ocean will often have this field left blank.
The name of the watercourse which the waterfall occurs along. If the watercourse is not known to have an officially or colloquially recognized name, this field is left blank.
The volume of water present in the stream at the location of the waterfall. This is often the most difficult figure to pin down because accurately measuring streamflow is not a simple process. We will rely on USGS data as much as possible, and attempt to take into account seasonal fluctuations in stream levels if possible. There is no guarantee that this figure will be accurate, and in cases where there is no USGS data to use, it may be a very, very rough estimate at best.
If known, the primary source of the watercourse which produces the waterfall will be listed here. This is helpful in determining whether a waterfall may flow more consistently during certain periods of the year - streams which originate in Springs, Lakes, or Glaciers will often flow more consistently throughout the year than those fueled by simply Runoff. The source of the stream may also be either unknown or undetermined.
A rough estimation of how many months out of the year the stream which produces the waterfall will actually hold water. The vast majority of waterfalls featured on this website will technically be truly perennial waterfalls (those that flow all year long), but some may see their flow dwindle greatly in the late summer months. This figure will not take into account the winter months when the waterfall may freeze, because in such cases the waterfall will very often be inaccessible. Entries which specify a Flow Consistncy of 12 Months should in general have an acceptable flow at any time of year (but may be better during certain periods - see below).
A general estimate of the best period of the year during which time the falls will be considered at optimal conditions, or flowing at their best. There may be variance within the range specified where the flow will be better or worse, but visiting at any time in the range specified (if available) will generally present the waterfall in its best light.Close
CatalogedWaterfalls which are Cataloged we have visited and surveyed in person. Statistical information should be quite accurate (for the most part), and exact measurements will often be available (information is not guaranteed to always be up to date). Detailed information, directions, and photographs will almost always be available.
ConfirmedConfirmed Waterfalls are known to exist, should be relatively accurately mapped and geotagged, and the statistical information available will often be dependable. If height information is presented, it may be estimated but should be accurate. Directions will not likely be available.
UnconfirmedUnconfirmed Waterfalls are often marked on a published map, but we have yet to confirm the exact location and / or whether or not its stature is significant enough to qualify for listing in the database. Statistical information may be estimated and may be inaccurate. No directions.
UnknownWaterfalls marked as Unknown are either suspected to exist based on heresay or a hunch, or we have received unverified information suggesting a waterfall may exist near the location provided but cannot corroborate it in any way. Geodata may not be accurate, the location may not be known at all, and statistical information will be estimated and highly inaccurate.
InundatedInundated Waterfalls have been submerged beneath lakes or reservoirs, usually a result of impoundment of a river behind a dam, and most often no longer functionally exist (there may be rare exceptions). We maintain records for these features out of historical importance.
SubterraneanThough not common, some waterfalls can be found entirely underground within cave systems. Access to subterranean waterfalls can vary from easy via developed walkways to requiring a high level of extremely technical spelunking skill, including familiarity with ropework and a distinct lack of claustrophobia.
DisqualifiedWaterfalls which have been marked as Disqualified do not have the necessary stature or features to qualify as a legitimate waterfall according to our criteria. We will maintain records for entries with this status where the feature is well known and / or may have been historically referred to as a waterfall at some point in time.
PostedPosted Waterfalls are known to exist, and we may have a large amount of information associated with them, but are located on private property and are not legally accessible to the general public. Accessing waterfalls with this status should not be attempted without first being explicitly granted permission of the property owner.